Not even halfway through book 1 of 6 on my 75419 Death Slice and I have an incorrect piece that stops the whole build
BlockTalk Summary
A LEGO builder encountered a frustrating issue while constructing the 75419 Death Slice, discovering an incorrect piece that halted progress early in the build. The builder, /u/HybridP365, shared the experience, highlighting the challenge of receiving a mispackaged element so early in the building process.
The specific problem involved a desert tan piece with pegs on the top instead of the bottom, preventing the build from advancing. The incorrect piece was identified in bag number 6. Fortunately, the builder was able to source the necessary part from another set, allowing the build to continue, albeit with a delay.
The early appearance of an incorrect piece in a large set like the 75419 Death Slice raises concerns about potential further issues. The builder expressed hope that no other incorrect or missing pieces would be found.
For anyone experiencing similar issues, having a brick separator on hand can be helpful for correcting small mistakes.
One of the desert tan pieces has the pegs on top instead of the bottom. And yes I checked, that piece doesn't even exist in this bag(#6). Edit: I was able to pull the piece from another set I can wait to build until later. But so early in the build for this large set doesn't bode well. Hopefully there's no other incorrect or missing pieces. submitted by /u/HybridP365 [link] [comments]
Read the Full Article
This is a summary. Read the complete story at r/legostarwars.
