Modeled and 3D printed an almost hidden floating shelf for the orchid

Originally published by r/lego

Modeled and 3D printed an almost hidden floating shelf for the orchid

January 18, 2026

<category term="lego" label="r/lego"/>

Discovered for you from r/lego

I left a little inset for a 2x2 plate to snap into, but the fit of the shelf’s ring around the round 8x8 plate was snug enough that I didn’t even need it! submitted by /u/TheFuckinEaglesMan [link] [comments]

Continue reading at r/lego

<category term="lego" label="r/lego"/>

Read the Full Article

This is a summary. Read the complete story at r/lego.

Read Full Article on r/lego